Day 6 - starting the make

We had a break for half term and I've realised that I'll miss the last session so I might be short of time but we'll see. I've started to form the body of the pot. I used a high-tech cardboard tube and some scrunched up paper to stop it sagging while it dries.


The bit I was worried about, the physical join between the two slabs, went well and should be invisible once its glazed and decorated. Less impressive was the fact that one of the slabs was the wrong way around. It required some trimming to make it look something like. At least with it being a large piece there was plenty of clay to play with.

The moulds are working out ok as well. The mould for the head worked and I played around with some decorations so I'm ready to go next week. The petals were just to flimsy and I might as well extrude them instead. So long as I shape them a big by hand that should be reasonably consistent.



The decoration on the left looks like something you'd use for testing in a wind tunnel, the middle one just looks dull so it'll be some variation on the right-hand decoration.


Comments

Popular posts from this blog

Day 3 - Slip Transfers and Sprig Molds